Bump...
I have made a large box (plenum) that I place the duct inside. The outside of the duct is exposed to atm, while the other side is inside the box. The box is airtight. I then know the flowrate into the box and know the P inside the box. So the R value can be obtained. But I still have...
Hi everyone, I'm currently a mechanical engineer interning at an HVAC company. I need to measure the resistance of a fluid through ductwork. The CFD shows a linear curve through a plenum when plotting R vs volumetric flow rate. For example, a straight rectangular box 1 1/16” by 2.5” and 3ft...
Well the original idea was to create an accelerator that we could charge up capacitors using the CW or VDG, and then release this energy into the magnets. And yes these are being accelerated in a vacuum.
High voltage supply questions! :)
Ok, well a few friends of mine have come together to build a fuser and an electron accelerator.
I have obtained an NST at 20ma 6 kv DC , but would like to build a crockcroft walton voltage multiplier for the accelerator. My question is, will this setup run off...