PDA

View Full Version : Need high range temp sensor ic


ironcross77
Jan5-07, 09:46 PM
most of the temp sensor ics goes upto 150 'c. can anyone suggest any ic that has upper limit of 400 'c? may be 350 'c

Averagesupernova
Jan6-07, 12:24 PM
Use a thermocouple.

berkeman
Jan6-07, 03:46 PM
... or a non-contact IR optical temperature sensor.

wrharper
Jan8-07, 05:51 AM
Both suggestions are good but in industry we use either "J" or "K" thermocouples with "K" being the most common where I work. If the temperature was around the boiling point of water I would recommend a RTD.

wrharper
Jan8-07, 06:26 AM
I just read you post without reading the replys. If a IC is so hot that you cannot place your finger on it for over 1 second, it is too hot! You either have a heat sink problem or a bad IC.

Averagesupernova
Jan8-07, 10:33 AM
Ummm, no. He doesn't wish to remove heat away from a part that is used as a sensor to meause temperature. His problem is that he is looking for something that most likely doesn't exist. He has admitted that he is unable to find it so he has been given a couple of choices. 350 degrees is far from the boiling point of water.