PDA

View Full Version : What's the best way to separate a dissolved mixture


Kombaiyashii
Jun15-11, 01:09 PM
Hi folks,

I like to recreate medival medicines from old manuscripts but I have come to a slight problem when it comes to the prepairation...

I'm trying to separate sodium bicarbonate which is dissolved in water. What I usually do is have a baking dish like the one below filled with the solution of water and sodium bicarbonate...I then put it in the oven on a low heat. After a while the water evaporates leaving mostly the sodium bicarbonate in the dish...

http://iweb.cooking.com/images/products/enlarge/183013e.jpg

The problems is that I can't get it very dry. I would like to evaporate all the water so I get a 100% powdered solution. If I carry on heating the solution, eventually the sodium bicarbonate crystalises which traps some water underneath and the crystals heat up and the whole thing starts spitting and then I get sodium bicarbonate all over my oven...


I was wondering if anyone knew a better way to separate the two and get a nice dry powder without too much work or expensive equipment?

Thanks,

Komb

DaveC426913
Jun15-11, 01:30 PM
Seems to me your solution should work OK if you just keep the temp below boiling and let it simmer long enough.

Or you could just put a lid on the pan. Does it matter whether your precipitate is collected in the pan or on the underside of a lid?

turbo
Jun15-11, 01:57 PM
@OP, do you have access to a dehydrator (usually used to dry fruits and vegetables)? Very little monitoring is necessary, and you can use the various trays to dry several solutions at once, if you like.

Borek
Jun15-11, 02:01 PM
Many hours at temp below boiling, that's more or less the standard procedure.

Some mixing/crushing during drying won't hurt - you will break the surface and allow water to escape.

Lid will slow the process, you want the vapor to be able to leave the volume above the salt, as salt will be not drying under saturated atmosphere.

DaveC426913
Jun15-11, 03:06 PM
Lid will slow the process, you want the vapor to be able to leave the volume above the salt, as salt will be not drying under saturated atmosphere.
Right. A screen then.