binto100
Sep18-11, 04:18 PM
Greetings.
I am asking for help connecting a Wago 24vdc power supply to a Galil motion controller. I have a very limited electrcial background.
The power supply (ps) has 120vac L-N-G inputs (I get that part) and outputs 24vdc/2.5A as two plus (+) outputs and two minus (-) outputs.
The inputs on the controller (con) are GND, +VIN, NC, and PE (the three pronged pitchfork symbol).
I'm guessing ps+ goes to con+VIN but the rest I'm un-certain about since the ps does not output a ground or common. I don't know if the ps- goes to the conNC etc etc. It seems I should also run a wire from conPE to the ground busbar in my panel?
A picture is below and believe me any help is really appreciated. Thanks.
Bruce
http://farm7.static.flickr.com/6162/6159735853_1d9e0a81ae.jpg
I am asking for help connecting a Wago 24vdc power supply to a Galil motion controller. I have a very limited electrcial background.
The power supply (ps) has 120vac L-N-G inputs (I get that part) and outputs 24vdc/2.5A as two plus (+) outputs and two minus (-) outputs.
The inputs on the controller (con) are GND, +VIN, NC, and PE (the three pronged pitchfork symbol).
I'm guessing ps+ goes to con+VIN but the rest I'm un-certain about since the ps does not output a ground or common. I don't know if the ps- goes to the conNC etc etc. It seems I should also run a wire from conPE to the ground busbar in my panel?
A picture is below and believe me any help is really appreciated. Thanks.
Bruce
http://farm7.static.flickr.com/6162/6159735853_1d9e0a81ae.jpg