paul11273
Nov25-04, 12:14 PM
Is anyone familiar with the Basic STAMP 2 microcontoller?
I have found a little information about it, but not much. I would like to start tinkering around with some type of microcontroller, probably something to run stepper motors. Would this be a good choice?
Specifically, I am thinking about a project that would automatically point an antenna toward the source of a signal for optimal reception. Would the STAMP micro be a good choice? What would be some good books / resources to learn about it?
If not, what alternatives are out there for this application?
Thanks.
I have found a little information about it, but not much. I would like to start tinkering around with some type of microcontroller, probably something to run stepper motors. Would this be a good choice?
Specifically, I am thinking about a project that would automatically point an antenna toward the source of a signal for optimal reception. Would the STAMP micro be a good choice? What would be some good books / resources to learn about it?
If not, what alternatives are out there for this application?
Thanks.