View Single Post
hirochiamaru
hirochiamaru is offline
#1
Mar28-08, 12:58 PM
P: 3
I have a data acquisition device that outputs 3 volts if the sensor is activated. My relay only activates when a 5 volt source is put across the coil. What is the easiest way to step up the 3 volt control signal.
Phys.Org News Partner Engineering news on Phys.org
SensaBubble: It's a bubble, but not as we know it (w/ video)
WSU innovation improves drowsy driver detection
Faster computation of electromagnetic interference on an electronic circuit board