View Single Post
Jim M
#5
Feb3-10, 11:37 PM
P: 17
Quote Quote by Mike_In_Plano View Post
Hello, I'm Mike from over on the EE board, and I'm looking for good advice regarding welding aluminum foil. I had a vendor that used to do so inside his capacitors and he even bonded the foil to solderable leads. Any ideas are certainly welcome,

Best Regards All,

Mike
I'm not too sure about the other methods in this thread, but I am fairly sure you can do this chemically at a low cost.
I had an example done way back in my highschool days. It involved a compound (flux and weld material) placed in the seem of two pieces of foil. THe foil was lowered into a container of fuild and an electrical charge put though it. THe electricity bonded the foil together.

Jim