Mixture of two gases. If we assume each gas behaves ideally,

AI Thread Summary
In a mixture of two gases, if each gas behaves ideally, the mixture can also be considered an ideal gas. This assumption holds true under the conditions outlined by Dalton's Law of Partial Pressures, which states that the total pressure of a gas mixture is the sum of the partial pressures of each individual gas. It's important to explicitly state this assumption when solving thermodynamics problems involving gas mixtures. Understanding the Dalton Model is crucial for applying these concepts effectively. Overall, recognizing the behavior of mixtures as ideal gases simplifies many thermodynamic calculations.
gikiian
Messages
98
Reaction score
0
I'm just starting to learn thermodynamics. I was just wondering that in case of a mixture of two gases, if we assume that each gas behaves as a ideal gas, does it imply that the mixture will also behave as an ideal gas? Or do we have to state it separately while making assumptions in our problem?
 
Engineering news on Phys.org
Yes I'm looking into the Dalton Model. Thanks :)
 
Ask again if you have more queries.

:wink:
 
Thread 'Turbocharging carbureted petrol 2 stroke engines'
Hi everyone, online I ve seen some images about 2 stroke carbureted turbo (motorcycle derivation engine). Now.. In the past in this forum some members spoke about turbocharging 2 stroke but not in sufficient detail. The intake and the exhaust are open at the same time and there are no valves like a 4 stroke. But if you search online you can find carbureted 2stroke turbo sled or the Am6 turbo. The question is: Is really possible turbocharge a 2 stroke carburated(NOT EFI)petrol engine and...
I need some assistance with calculating hp requirements for moving a load. - The 4000lb load is resting on ball bearing rails so friction is effectively zero and will be covered by my added power contingencies. Load: 4000lbs Distance to travel: 10 meters. Time to Travel: 7.5 seconds Need to accelerate the load from a stop to a nominal speed then decelerate coming to a stop. My power delivery method will be a gearmotor driving a gear rack. - I suspect the pinion gear to be about 3-4in in...
Back
Top