When is a magnetic core considered "saturated"? At 50% of core - 100%?

VinnyCee

So I am doing some simulations of inductors on the Ansys Maxwell software for electromagnetic simulation. I have a simple inductor with a Metglas core and copper coil. I'm trying to figure out what current is required to bring the core into "saturation" but I'm not sure what constitutes "saturation"!

Metglas datasheet says that the material is in saturation after a B-field of 0.77 Tesla is induced upon it. So what does that mean, that a 0.77 T field must be present in ALL of the core, or just 50% or just in the area covered by the windings?

Here, the middle 50% of the core is over 0.77T:



And here the whole core is over 0.77T:




Is there a standard for determining when a core of a specified material is truly operating as a saturated core?

Enthalpy

Saturation is measured on toroids, where the induction is uniform over a full circle.

VinnyCee

What about for rods as like above?