Recent content by AdrianRodz1

appologies, approx 55amp

I believe the answer was in my reply, was it not? "100V"

Hi Berkman, Thanks for the welcoming.. I'm appreciating all the reply's, Thank you all! My board is stnd .062 w/2 oz planes utilizing multiple layers to supply 100v to a single chip. I had a choke point on one layer that I missed, so I used some of, one of my gnd lyrs. :) Problem solved

I'm trying to maintain a spec requirement of less than 3% drop from farthest pin to closest pin from source. I'used the entire layer for copper but my oart does not require such a large pour accept to handle high current. So I'm considering there's a trade off that should meet inthe middle of...