Recent content by Akita

im trying to use my engine and transmission as PTO to power hydraulic pump shifting from either D or R to any other positions forces grinding as there no driveshaft and I am assuming inertia keeps trans spinning ,so it made ugly noise until i turned off engine 3 secs later.

took off driveshaft,both reverse and drive spins at tailshaft.but problem is there's no brakes to stop spinning in either direction and it grinds trans inside every time i switch gears.Now i have to figure out at what gear transmission spins at 1500,2000,2500 rpms.

i'll check it out now physically,will get back later today :D

im trying to use my engine and transmission as PTO to power hydraulic pump,engine in first 2 gears lowering ratio 2.70 and 1.70 depend on gear rpm range comes 500-800rpm ,pump needs 1800rpm or 3000 if i go gear type to achieve max performance.I want to alter shifts and rev engine up to 2500rpm...

[Moderator note: This thread was moved from a HW forum. Hence the template. But it doesn't sound like homework.] 1. Homework Statement What will happen if i disconnect driveshaft from transmission and rev engine in drive? Homework Equations Rear end speed sensor could be play some role in...

i got it,all numbers kinda straight now. thank you guys.

i found some data Nail Withdrawal and it says 2 inch nail uses 59 lb in OSB 7/16,id guess double that in pine planks so 100 lb. 430 in lb is for coil roofing nailer force ,for 3/4 to 1 3/4 nails ---------------- im designing wedge acting tear off tool for shingles and wanted to calculate how...

Homework Statement Roofing coil nailer drives with 430 in lb into plywood,decking 1.5" nail How much force do i need to pull the nail out ,i don't know what else holds nail in place other than friction ELI5 ,im as uneducated as it comes. :D Homework Equations i don't know any The Attempt at a...