Recent content by AM1990

Might be these picture could help you also term "triangle" is just used for reference as it has a uniform shape that looks like a "triangle".

I am willing to add 2 leaves in total but I am confused where to put them. As it is obvious that a leaf suspension looks like triangular shape, so I am not sure its triangularity would be affected of not? If so then what would be the result? or shall I need to modify other leaves too to maintain...

Hi. If I am going to increase pay load on a truck (within front and rear axle capacity). It is supposed to modify or add leafs in semi-elliptical leaf spring. I want to know what should be the max considerations for doing so? Just adding some leafs in suspension can fulfill the requirement? or...

I have found that Battery cut off switch is basically a Battery Relay controlled by a switch that turned it on/off as per requirement. And also I have found a solution to my case. Thanks for your sharings.

How car alternator charge battery..?? Both equipment are connected with same cable so why battery power does not reached at alternator?? If you guys have any animation it would be helpful..

Thanks for your replies. I have done with a physical experiment. and that switch was actually for fog lamp, having 2 lights within switch (one to be light up as parking lights are on and the other when switch is turned on). you may check the picture for sample I have found a solution that I...

yes you are right. I will get back to you as I gain some basics to do this sort of changing.

Hi, I have two sort of switch one is 5 pin (push type) switch and the other is 2 pin (on/off) type switch for my vehicle. Can I use first one instead of On/Off switch. In continuation, If I have two wires on which any of mentioned switch is to be applied, then How can I use 5 pin switch on that...

For my case there would be another problem that if we cut the battery off when the engine has been started then other equipment would be turned off. But at that moment If ignition switch is turned off, then switch/engine will not stop as no power would be there to operate ignition switch/motor...

@CWatters I am new to physics forum so if this thread should be in electrical section, then they may shift it. From your reply, If I want to operate hazard light even cutoff switch is turned on then I should supply power at those fuses belongs to hazard light so it can be operated when every...

actually cut off switch refers to a switch that turned off power from battery so that discharging of battery could not occur when the vehicle is switched off. But If you completely cutoff the battery (power from battery) by turning off the cutoff switch, then no electric equipment can be...

How battery cut off switch works?? How to apply Battery cut off switch on a vehicle..?? I want to make some electric functions to be operated if the battery is cut off. For this what should I do..??

I have a question that how ignition switch works. Is it is directly connected to battery..? or Alternator..?? Further If I apply a Battery Cut-Off Switch, will ignition works when Battery Cut-Off Switch is off..??

I will try to pull stumps if modification would done.. :-) Thanks for your kind information.. Have a blessed life.. :-)

so I should consider Mileage and Top speed as both will be affected. And If the engine is going to be run on High RPM than it will decrease its durability and causes high engine room temperature to be occurred.