Recent content by Arifur

Thanks to all of you for help, but the Plc power is on and the fault indicator floushing, from the Plc manual it's for application fault and it can minimized. So, please help me to minimize this. If there are any hardware failure then the fault indicator should solid on. Thanks again

No technical support is not available here.

Hi, everybody today I have got a problem in my Allen Breadly PLC which is after getting emergency HMI shows emergency button pressed and after pull the emergency it can't reset and it was noticed that Plc fault indicator shows blinking. I have checked all corresponding issue & make all things...

What is Earth resistance? What is the standard value of Earth resistance? Please help me with reference. Your co operation will be highly appriciated.

[FONT=Arial]What is the basic reason of unbalance output of an inverter, even the output connection is open and the IGBT is ok. Can anybody tell me what is the problem? Co operation is always encouraged.

How to calculate condoctor size for different types of load like resistive load, inductive load or capacitive load etc and what will be neutral wire size for these load? Any body please help me. Thnx

Thnx Hesch for your suggestion, but there is no screech between rotor and stator. In case of winding failure it won't run, isn't it?

After bearing failure of 24V, 15A dc motor. We change the bearing of the dc motor. But after changing it the motor is running forward/ reverse but there is no control over the speed. Where is the problem? Is that in the techo or drive card? Any body please help. Helping in highly appreciated...