Recent content by c d

Thanks for the recommendations. Just ordered a set of replacements. Thanks everyone!

I need to replace a mosfet for a 3D printer. The seller and manufacturer were contacted on this but were not able to fulfill a replacement. See this on mosfet: IRF3205 P705D KCAB Here is photo: https://plus.google.com/photos/photo/103754471497291178620/6538401194800693618 Unable to find...

Red goes to positive of lipo and "input" terminal (middle of three wires) of voltage regulator, thanks for asking. btw, "input" is 15.5 V [positive] with respect to ground. Reading the "output" terminal with respect to ground and getting the same...

[mod note: thread moved from homework forum] I have this Mouser voltage regulator https://www.mouser.com/ProductDetail/STMicroelectronics/L7912CV/?qs=sGAEpiMZZMug9GoBKXZ75xbXFDWiKqpmvrbz5I0HaKg%3D Wired according to datasheet https://www.mouser.com/ds/2/389/l79-974159.pdf see insert photo...

i see the bucks are efficient and cheap! I'll give those a try.

I'll go with the low current answer. Unfortunately, most of the m-meters I own do not measure current, also don't see anything in the tx specs. BTW, the wires in the splitter are about .01 inch in diameter. 7812 regulator would give me 12 volts out; just ordered several. Let me add this to...

Hi I have a lipo 14.8 V battery to power a motor. I want to use same battery to power a video transmitter, a TS832. The tx takes a 11.1V input. Made a voltage splitter off 14.8 battery that produces 11.4 V with respect to ground. Does not power tx when plugged in. When I plug a 11.1 V...