Is the STMicroelectronics L7912CV Voltage Regulator Suitable for a +12V Output?

Click For Summary
SUMMARY

The STMicroelectronics L7912CV voltage regulator is designed for negative voltage regulation, specifically providing a -12V output. In the discussion, the user reported an input voltage of 15.5V but observed no voltage drop at the output, indicating a potential wiring error. The consensus suggests that the user may have connected the battery incorrectly, leading to the regulator's malfunction. Proper load conditions and capacitor specifications are critical for optimal performance, as negative regulators can exhibit issues under light load conditions.

PREREQUISITES
  • Understanding of voltage regulator types, specifically the 79XX series for negative regulation.
  • Familiarity with basic electronic components, including capacitors and diodes.
  • Knowledge of wiring and circuit design principles.
  • Ability to interpret multimeter readings in relation to circuit ground.
NEXT STEPS
  • Research proper wiring techniques for the STMicroelectronics L7912CV voltage regulator.
  • Learn about the specifications and applications of the 79XX series voltage regulators.
  • Investigate the importance of load conditions in voltage regulation performance.
  • Explore the use of bypass capacitors and their impact on voltage regulator stability.
USEFUL FOR

Electronics hobbyists, circuit designers, and engineers working with voltage regulation in power supply applications will benefit from this discussion.

c d
Messages
7
Reaction score
1
[mod note: thread moved from homework forum]

I have this Mouser voltage regulator

https://www.mouser.com/ProductDetail/STMicroelectronics/L7912CV/?qs=sGAEpiMZZMug9GoBKXZ75xbXFDWiKqpmvrbz5I0HaKg%3D

Wired according to datasheet https://www.mouser.com/ds/2/389/l79-974159.pdf see insert photo.

https://plus.google.com/photos/phot...0/6526650605024626690?authkey=CPTx7ezW74_OiAE

Would expect to see 12 V output. Input is 15.5 V Wired this a couple of times, get same output as input.

Before I go a lot further, am I on the right track? Your thoughts?
 
Last edited by a moderator:
Engineering news on Phys.org
cd, do you have the red lead going to the negative terminal of the LiPo?

Interpreting your meter reading, is the O/P positive or negative with respect to ground?
 
Red goes to positive of lipo and "input" terminal (middle of three wires) of voltage regulator, thanks for asking. btw, "input" is 15.5 V [positive] with respect to ground. Reading the "output" terminal with respect to ground and getting the same...
 
Spec sheet calls for a C1 value of 2.2 uF for tantalum, but 10x or more when an electrolytic is used. Probably want to add a back diode across the output, too, but I don't think that's the problem. Negative regulators (more so than positive regulators) have a tendency to exhibit this symptom when under no load or lightly loaded (under 5 mA) conditions.
 
Why do you have the input positive with respect to ground on a negative voltage regulator?
 
  • Like
Likes   Reactions: berkeman, CWatters and dlgoff
c d said:
Red goes to positive of lipo and "input" terminal (middle of three wires) of voltage regulator, thanks for asking. btw, "input" is 15.5 V [positive] with respect to ground. Reading the "output" terminal with respect to ground and getting the same...
79XX series are negative regulators. From what you say i'd guess you hooked the battery backwards. Likely it's shot now.

edit - average supernova and i crossed in the mail..
 
  • Like
Likes   Reactions: rbelli1 and dlgoff
The 7812 series are for +12V.