Recent content by Canagman
-
C
UHP water jetting and calculating kinetic energy
no i do not, however i did stumble upon a research paper has the calculation and 420 MPa, 1 mm orifice = 916 m/s this was verified thru CFD and measured using phase Doppler anemometry...that was thru a single orifice...i need look thru the rest of the formulae and work thru the impact of that...- Canagman
- Post #6
- Forum: Mechanical Engineering
-
C
UHP water jetting and calculating kinetic energy
In addition, is there a specific energy dispersion rate from the nozzle tip to atmosphere?- Canagman
- Post #4
- Forum: Mechanical Engineering
-
C
UHP water jetting and calculating kinetic energy
I have drawn this in metric units. Scenario # 1 (Solenoid valve 2 opens, pump is supplying noted pressure to water) What is the velocity of the stream exiting attached nozzle? Power of stream? Scenario # 2 (Solenoid valve 1 opens...Valve 2 stays open)...- Canagman
- Post #3
- Forum: Mechanical Engineering
-
C
UHP water jetting and calculating kinetic energy
If i compress water to 60 ksi, and push it through a 0.015" sharp orifice, then i have another orifice 2 feet before that sudden open to 0.015", what is the velocity of the stream from each orifice?- Canagman
- Thread
- Energy Kinetic Kinetic energy Water
- Replies: 5
- Forum: Mechanical Engineering