Recent content by electro-man

  1. E

    What is the missing value in this parallel RC circuit problem?

    dumwit atleast type what you are asking properly
  2. E

    Optical fiber transmitter and receiver (photodarlington)

    Hello, How can we convert parallel-to-serial address and send it as an optical signal? Have a look at the link below if you folks don't know what I mean - the last (3-4 lines) paragraph of the pdf file: http://www.hep.yorku.ca/menary/courses/electronics/3150/lab_manual/opt.pdf...
  3. E

    Efficient 4-Bit Binary Subtractor Design Using Half-Adders and Full-Adders"

    Or may be u're not "good enough" to see the answer and if wrong, "steer" as you say, in the right direction! :-p
  4. E

    Efficient 4-Bit Binary Subtractor Design Using Half-Adders and Full-Adders"

    You didn't tell me anything about the "figure" attached I just wanted to know if its OK ? u
  5. E

    Efficient 4-Bit Binary Subtractor Design Using Half-Adders and Full-Adders"

    c'mon jack asses move ur ass and check the ans. atleast! or r u all That dumb?
  6. E

    Efficient 4-Bit Binary Subtractor Design Using Half-Adders and Full-Adders"

    Hello folks : the task is to design a circuit which subtracts 4 bit binary number a3,a2,a1,a0 and b3...b0. the MSB is a sign bit. Assume that you are given half-adders and full-adders, i.e. you don't have to design the logic of the half-adder or full adder chip. the two numbers are fed...
Back
Top