Recent content by geordy

what would happen if i removed the condenser and the breaker switch exactly? then what on the circut board can i do to enable more current? is it possible to answer that one, like all i need is a circut board that will throw out high amounts of current that can be fed off a 12volt battery or a...

Is it possible shoot a spark down the likes of a cable much like an ignition coil cable that can be attatched to a magneto? in other words the if you didnt have a lead on the end of the magneto is it possible to discharge electricity being made out the end of the magneto, if modification is...

with that rotating permanent magnet is that continuousy spinning causing continuous spark? how much amperage would come off one of these?

how does a magneto work? does it have high amperage? if not how do i increase the amperage so it is high flowing current? is the spark coming from a magneto constant meaning does it continue to pulsate an electric spark NOT in terms is it constant AC or DC? My aim is to find something with high...

Say you had a normal fan and you attached a type of differential to the fan square in the middle then that diff ran your back wheels. But what what's running the fan you may ask.. Say you had two turbines like turboes for the car that were sucking in air and blowing the air directly to the fan...

I want to be able to sit in the car wait a couple of seconds and let the electrodes do its work by building up hydrogen in the tank, then when there is sufficient amount of hydrogen gas to run through to the fuel lines then into the cylinders the car will run and keep producing hydrogen on...

well my aim is break up water via an energy source such as an engine, and i need an on demand system that will rapidly break down the water as you accelerate and in turn make fuel on demand with the highest and safest output possible of current.

Hi i am new to this but i have a question, I am fascinated by exploiting water and removing the hydrogen from the water, and to my understanding i need to advance in higher current to make it worth while to break the water up at a higher and much faster rate, is it hard to make a device that...