Recent content by jxlee

Now i have a motor with quadrate encoder from MicroE-Mecury Model 1510-S with A- A+ and B- B+ Signal, and i want use my Advanced motion controller (BE15A8) to drive the motor. From the driver its only have Single-ended encoder A and B. So can i just connect the A+ and B+ from the encoder direct...

I have one quadrature encoder with A- A+ and B- B+ Signal, but my driver is a single-ended encoder channel? Can i just connect either the A+ and B+ or A_ and B- signal to the single-ended encoder channel? Please advise. Thanks

Thanks Sir..Thanks for the info...=)

Thanks Sir...But a motor is build up with coil same as transformer.So if we let the transformer switch on with no load connect to it,is it will burn also?

Thank,Sir...But if we despite the overload switch.We just supply the normal power to the motor and with the rotor locked.So ijust want to know will the motor burn out or it still can operate like before after we remove the locked?

This mean every motor have this thermal overload switch,and how this thermal overload switch operate?

Ya.I want to test the characteristics of the motor.I want too find out if accidently the motor rotor is stuck but the motor power supply are still switch on, so will the motor burn? And what is the causes to this? By the way,may i know what is the motor overload switch?

I have a AC induction motor,i use a strong clamper to lock the motor shaft.Then i switch on the power supply.? So,i want to ask is there the motor will become short circuit? Can i know what is the cause for this malfunction?Is that the motor stator burn out or they still got other reason...

If i switch on a transformer but with no load connected to the secondary path.Is the transformer will burn?