Recent content by kardamyla

Sorry about that

I assumed that pin 4 and 5 on the relay is the output for the light? And this relay can handle 120-240 volts up to 500 watt. I should get more involved with Electronics, very interesting. THANKS TO ALL OF YOU FOR YOUR HELP AND PATIENCE . With best regards, George

OK finally got it the Arrowhead stripe of the diode to the #2 I/O connector of the camera and the other end of the diode to #4 I/O connector. The relay coil is pins 1 and 6 , one goes to the I/O connector of the camera pin #2 and the other terminal to pin #4 You also mention that "such...

Thank you Sir, I got this diode 497-6478-6-ND hope it works. "The diode has a stripe on one end. Mnemonic: "Arrowhead points to stripe." Go to that drawing on page 43 of camera manual stripe on diode goes to pin two, 'up' on that drawing unstriped end to pin 4" I think I got it...

Is there a diode that you recommend from digikey to use with Z712-ND relay, and if I understand correctly you solder the band part of the diode to pin #2 of the relay, "The + terminal of the relay coil should go to pin #2 and the - terminal to pin #4". As i mention before, I would like to...

Again many thanks for everyone trying to help me, This relay seems to have a diode, do you know if it will work and how to hook it up. Also is that 120-240 volts output. I was going to use 1000 watt but after reading the post 200-500 will do fine...

I came across another relay and want to know if this may work for me...

THANKS A MILLION, I have been trying to get some help from someone for over 5 weeks, and I came across this forum. There still people that willing to help. The part number for the relay is http://www.digikey.com part number Z2909-ND , That is the one digikey suggested , I don't know...

Hi, I do not know anything about relays. I been trying for days to hook up a relay to turn on a light using an Axis camera with an I/O switch. This is the relay http://search.digikey.com/scripts/Dk...536&DPU=submit This is the manual for the Axis 207 207W camera...

Hi, I do not know anything about relays. I been trying for days to hook up a relay to turn on a light using an Axis camera with an I/O switch. This is the relay http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&itemSeq=105585863&uq=634536768231996536&DPU=submit This is the manual...