Recent content by NYAME EPHRAIM

Hi thanks for the reply. my target is to fill that table, those value of resistor in that ladder circuit we don't have most of the values practically, that's why i had to reduce the 9 to 8. please take a look at this diagram and cross check.

Hi, thanks for the reply, the diagraim was presented that way for me to do the calculations, i have also seen related diagraim online for DAC! Yeah it,s ladder

Homework Statement Homework EquationsThe Attempt at a Solution

well when you power it up the output should be zero, one you change the stat ot any J or K, then one of the outputs will be high, the you can use the clock pulse to change the output state, as you apply the pulse the output state change one side becoming high and the other low!

it does not work when i simulate it, i don't know if the nand gates i used are the current gates or they are specifications ?

project it does not it does not even simulate in the first please

< Mentor Note -- thread moved to HH from the technical forums, so no HH Template is shown > a) Using the Yenka (or similar) simulator, you are required to build an RS flip-flop using 2 NAND gates, switches, LEDs and 330Ω resistors. Test the circuit and prove its correct operation against the...

Thank Sir please i need to be clear about some, if you see my results data, i have results for 10k ohms resistor, and 100k ohms resistor, how can i input this in the same graph paper or i need to do it separate ?

i have build and simulated the op amp circuit, i have recorded the voltage gain at different frequencies, now i need to plot a graph for the two results in same graph paper, i have not plotted a graph before for the related task so i need to understand from the basics, i need some one to...