Recent content by putta

  1. putta

    What is the voltage allowed Earth to Nuteral

    Hi Normally our electrical equipment systems neutral to Earth voltage showing 1.4 to 2 volts AC. Our requirement neutral to Earth is 0 volts. How to achieve this value ,please help me. What is the normal acceptable voltage of neutral to earth.
  2. putta

    Clarification transformer circuit

    Yes L16 & L13 only I measured 257VAC. Here L13 is connected to light circuit L16 is power out let circuit. The ground is not connected to X2&X3 points that point directly connected main electrical panel zero potential (neutral "N"). Earlier my images indicated TB point "N". My machine is...
  3. putta

    Clarification transformer circuit

    Dear Jim sorry for my late reply. i have checked all above your suggested conditions. i open neutral point from the circuit, when i checked at 219CB shows 257.06VAC. wire point (H16,H13). H16,H13 is connected our electrical control panel TB for out late sockets. i have traced the neutral cables...
  4. putta

    Clarification transformer circuit

    The right side is modification proposed drawing my supplier replied me the i.e (We don't need to consider 120v port as it is in x2 & x3. We need to hook the field wiring on the port X1 & X4 for 240vac.) i will take neutral point at any other location in the circuit it will work? If their is...
  5. putta

    Clarification transformer circuit

    attached image: the transformer taping is correct 120+120=240V? where i take taping of transformer nuetral point? the both are consider is 240V out put in two different faces? please if any wrong in circuit help me or it good i will proceed. here i attached circuit .pdf
  6. putta

    How to fix pressure transducer to Hydraulic line

    Dear Experts, I want to put new feature for my hydraulic pressing station (capacity:-350TON). present it existing with dial type pressure indicators. and directional propositional valve 3/4 for pressure lines. here value are made DAIKIN (JSO-G03-2CB-10) this model top side Alean key thread...
  7. putta

    Single CT (600/5A) to infeed PLC Analog card+Amp analog meter

    Thanks again to your solutions. here i attaching my circuit connection CT name( TP3)& explained in arrow marks. my Analog meter back side is have screw studs, like your attached image in earlier post. i expecting connection circuit help me. my Action Park part number 6380-0000-1 ( Action model...
  8. putta

    Single CT (600/5A) to infeed PLC Analog card+Amp analog meter

    for my confidence to do i need connection circuit diagram,of series resistance connection with Analog meter of CT Secondary . if possible please provide to me. Thanks for your support above
  9. putta

    Single CT (600/5A) to infeed PLC Analog card+Amp analog meter

    for my confidence to do i need connection diagram,of series resistance connection with Analog meter of CT Secondary . if possible please provide to me. Thanks for your support above
  10. putta

    Single CT (600/5A) to infeed PLC Analog card+Amp analog meter

    Hello, i have Current Transformer 600/5A, it connected with Amps Analog meter (0-600A @class2.5). i want to update without remove connection of old analog meter and update PLC analog input card +signal convertor 0-4mA, my doubt is will take connection for both (measuring device) at same point...
Back
Top