Recent content by questionpanda
-
Q
Fluid dynamics with T-junction vs separate riser in tank pipe system
I assume the length of pipe you suggest eliminating is the vertical riser to the tank inlet? Extending the horizontal 100mm (4") pipe into the side of the tank may be problematic. Due to the curvature of the water tank side wall, it will be difficult to fit a 100mm (4") bulkhead fitting to the...- questionpanda
- Post #7
- Forum: Mechanical Engineering
-
Q
Fluid dynamics with T-junction vs separate riser in tank pipe system
At jrmichler request, I have updated the diagram to include some dimensions. The original post only showed a single Source (A), however the actual system has two sources/downpipes. Not sure if this complicates things :confused: From the research using the AI chatbots, I believe there are...- questionpanda
- Post #5
- Forum: Mechanical Engineering
-
Q
Fluid dynamics with T-junction vs separate riser in tank pipe system
Hi there! First time poster. Hopefully posting to the correct forum :smile: The attached image has two different pipe setups. Both setups have a tank with an upper inlet (A) and a lower inlet (B). Inlet B is half the diameter of inlet A. The setup on the left hand side has inlet B...- questionpanda
- Thread
- Replies: 6
- Forum: Mechanical Engineering