greetings.
thank you for your answer and advice.
yes that's right, for now, there are no answers.
For the other information, yes, this engine is composed of a stator which has a resistance and an inductance.
A rotating rotor that has permanent magnets to generate a constant flow.
There are...
greetings.
I designed a system on simulink.
it is missing a pmsm.
I found a block on simpowersystems in simulink nde matlab.
I hope that this engine provides a nominal power of 96kw and maximum of 100kw.
so how to test it? to verify that this engine can deliver these two powers?
cordially. said.
the electric motor (PMSM) data are:
number of phases: 3;
Stator phase resistance Rs (ohm): 0.091;
Inductances (Henry) [Ld (H) Lq (H)]: [0.001597972349731, 0.002057052250467];
Linkage flux (Weber): 0.175666143629361;
I'm a beginner with Simulink. my level of expertise with Simulink is: initiation. No, I do not ask to make my project for me. I have difficulties, sizing blocks cobstituant my global system. I can send you figures of the block in question. for the experience with Simulink I have some and I have...
for the pmsm "it is the synchronous motor with permanent magnets. for the fuel cell datasheets and the supercapacitor pack is that you have internet links on that?
Hi, and thank's for your reply donpacino.
Yes it's a HUGE question. Sorry.
For the moment i like use only the fuel cell connected from boost dc dc converter. This device will feed inverter which will feed the pmsm.
So, now i need calculate parameters of fuel cell and boost dc dc converter.
I...
Salutations.
I néed help from how to choose the paramèters of under system which are fuel cell and bank of supercapacitors .
Fuel cell is connected to a boost dc dc converter.
Bank of supercapacitors is connected to a buck boost dc dc converter.
Also i need help from how i choose the schema...
greetings.
Thank you for your reply.
here you are right. during acceleration, supercapacitors must be used.
The energy management system in a hybrid also charges supercapacitors or batteries using dynamic braking.
right now I'm using a combination of a fuel cell with a pack of supercapacitors...
salutations,
i need help from modeling supercapacitors and buck boost dc dc converter with simulink of matlab.
my problems is: how choise parameters from supercapacitors and converter ?
this block will be used for supply the inverter, and pmsm.
cordialy
greetings, here I found a Simulink model on mathswork, I want to replace the battery with a fuel cell, so I'm stuck at the level of the energy management block.
here is the link of the model:
https://www.mathworks.com/matlabcentral/fileexchange/28441-hybrid-electric-vehicle-model-in-simulink...