@Nidum I have attached the rough design of the this system in attachment. The chain wheels (sprocket) are 62.7mm outer diameter. The centre to centre distance of rollers will be around 38mm. The rollers diameter will around 25mm. I have attached size chart for sprockets for your reference if you...
Thank you very much nidum for your reply. your this reply helped me a lot. I should use these two rollers (check attachment) as tensioners in place of tensioners I showed in my previous replies. These rollers might will not lock it up and danger of breakages might will be removed. check it and...
CWatters, 256bits and Nidum you people made me to think that these tensioners might not be able to make the middle sprocket get 7-8 kg torque for rolling the load on its shaft.
The arrangement I showed you in my previous reply was not exactly I will make, it was just to give you people an idea...
Thank you very much Nidum you gave actual right solutions for it. You understand the concerns of designing.
Thank you berkeman for your suggestion but I can't use it in triangular arrangement, as I had told in thread name that it needs to be in horizontal arrangement as in pic I showed.
By the...
Hello people, I have a serious design problem for designing a sprocket-chain system. I want to know that can three sprockets as in picture (in attachment) can be rolled by a chain? The main concern is for middle sprocket it have few teeth above and few teeth in bottom connected to chain. The...