Hello,
I cannot figure out which pump or size of pump would fit the need I have. Can you please review the need and recommend a type and pump model/specification that you think would work for this application?
I need to have a fluid flow of these specs, I don't have any constraints or...
Alright, Here's the idea
I researched online that a Gas engine piston chamber generates about 600-800PSI at compressed/ignition/power stroke of 4 stroke process. If you have a bolt cutter compound lever jaw mechanism that can take 50Lbs of force and translate that into 4000 lbs cutting force. I...
I have a good idea for a linear actuated drive system for automobiles and engines in general. I need a recommendation for a linear actuator that has a stroke of up to 18 inches, can perform very fast cycles of actuation and retraction in a controlled fashion, around 25 to 50 Hz. Needs to provide...
A school mate of mine was joking when he said you can lift your wind tunnel up if you mount the airfoil to the sides with the high Angle of attack and fast enough airflow. Is this true? If you have say a rectangular glass wind tunnel (fish aquarium shape) and put a large size wing and fast...
Foil Simulator
I found a free hydrofoil simulator that I am working with. But I posted here the values it calculated and I am trying to get a verification on the results. And also a real world opinion such as" Yes the values are correct for the input, but the foil is in a stalled state"...
There are a few fundamentals to energy usage and how to effectively supply more energy demand while the source of energy is reducing as in oil and becoming increasingly toxic and costly such as nuclear production and waste.
So breaking down the utiliation of energy into transportation...
I downloaded a hydrofoil simulation calculator and wanted to verify the results I am getting.
Can someone tell me if the following numbers are accurate? I am trying to get the highest amount of lift I can for a constant water velocity over hydrofoil of 20m/sec or 38.9Knots. I am also trying to...