Recent content by Y_G

Actually I was able to solve the problem. Older versions have limitations. The problem will be solved by modeling in new versions. ANSYS Electronics Suite instead of Ansoft Maxwell!

Hi everybody, I encountered a problem simulation of permanent magnets (PM) in Ansys Maxwell. There are many PM in my simulation and I need to define for each of them a proper coordinate system (CS). But I could only defined 255 CS. After that I can create new CS but It won't be possible to...

Thank you, in another simulation I want to apply I(t) (current of coils) , corresponding to voltage calculated in previous simulation. I hope that corrects the force exerted on PM somehow. I'll share here the results.

Thank you so much for your help. Despite of ordinary generator, maybe it could be possible to omit the gap between rails and PM. Also I'm curious about reducing the force on PM. If the force is reduced to a minimum level the efficiency of the generator will increase significantly.

Thanks

Thanks for replying. I only defined stranded coils with terminals. I don't know if it could be a open circuit or close circuit.

This is a kind of generator, If we could say. Sliding Generator. So I think, It should be modeled open circuit for voltage. Actually I defined another parameter for calculating force on moving magnet in x-direction. But I'm aware because of magnetostatic simulation the force may different from...

Thank You, 2000 turns for each coil. I did this modeling in two ways. 2000 and 1000 turns. In the first case, the amount of magnetic flux obtained was higher. To calculate the induced current in the coil, assuming the AWG24 wire, I calculated the length of the coil and obtained its resistance...

I'm trying to simulate a Magnetostatic problem. In my model there are two coils and a reciprocating permanent magnet. I defined a parameter, Xpm (movement of permanent magnet) in x direction to imply the reciprocating movement of permanent magnet like a piston. Xpm = f(t). I defined "t" as sweep...

I'm Yaser, a civil engineer who loves physics and mathematics. I'm an expert in CFD specially simulation with Flow-3D. I also have some experiences in Multibody Dynamics Modeling by Autodesk Inventor and COMSOL Multiphysics. I hope we expand our knowledge here by sharing our experiences and what...