enigma
Apr3-04, 08:57 PM
Hopefully someone here can help me... I'm almost at my wit's end
I'm trying to build a driver for a pin connection in an assembly so that I can restrict the range of motion and make an animation
When I select the connection, the default positive angle direction is not the way that I want it. I hit the 'flip' option, and it flips the positive direction, but then when I go into the 'select zero' menu, it acts as if the positive direction is the default. Since I want to define the range of motion, whatever I select ends up as allowing everything other than what I want.
It's driving (no pun intended) me crazy.
Attached is the picture. Basically, I want the long bar to extend outward (to the right).
If it makes a difference, I'm using v2001 student.
I'm trying to build a driver for a pin connection in an assembly so that I can restrict the range of motion and make an animation
When I select the connection, the default positive angle direction is not the way that I want it. I hit the 'flip' option, and it flips the positive direction, but then when I go into the 'select zero' menu, it acts as if the positive direction is the default. Since I want to define the range of motion, whatever I select ends up as allowing everything other than what I want.
It's driving (no pun intended) me crazy.
Attached is the picture. Basically, I want the long bar to extend outward (to the right).
If it makes a difference, I'm using v2001 student.