View Single Post
VinnyCee
VinnyCee is offline
#3
Jan17-07, 04:47 AM
P: 492
Ok, so I get these for the node voltages(4,3,2,2,1):

[tex]V_4\,-\,0[/tex]

[tex]V_3\,+\,5V[/tex]

[tex]V_2\,-\,0[/tex]

[tex]V_2\,-\,2\,-\,V_4\,=\,0[/tex]
[tex]V_2\,=\,V_4\,+\,2[/tex]

[tex]V_1\,-\,0[/tex]

Are these right? If not, how am I supposed to make these voltage equations?

Also, I am stuck again, I don't know where to go from here (even if the voltage EQs are correct)!

Should I use KVL or KCL? I tried to add 2 current variables at Node 2. I used KCL there and I made some EQs for the currents there (that I had an R for) using [itex]i\,=\,\frac{V}{R}[/itex]. I am seriously stuck now though!!!

Can someone walk me through the most logical way to proceed from here, I am really confused. Thanks