Register to reply

Comsol moving boundary with loss of mass

Share this thread:
SSS_04
#1
Jan30-13, 08:26 AM
P: 1
I need some help!My problem is a problem of moving boundary with loss of mass.... I started to use COMSOL and I need to simulate one plate with a hole on the center. And this hole is increasing with the time according to one equation (like a velocity, in m/s) which depend of the stress. Someone knows how to do this? Can I do this whit the moving mesh? Or I should use the DG?
Thank you!
Phys.Org News Partner Engineering news on Phys.org
Tiny UAVs and hummingbirds are put to test
Britain to trial driverless cars from 2015
NIST corrosion lab tests suggest need for underground gas tank retrofits
niklas.r
#2
Feb7-13, 03:09 AM
P: 2
It is not clear to me what exactly you mean with mass loss here. If the structure is changing shape due to applied stress (->strain), use the Moving Mesh interface. If the structure is changing shape due to material removal/addition, use the Deformed Geometry interface. This link gives some more info:
http://www.comsol.com/support/knowledgebase/970/
regards
Niklas (COMSOL employee)
ishantj
#3
Feb7-13, 06:22 AM
P: 2
This might help you in explanation.


Register to reply

Related Discussions
COMSOL moving boundary model Mechanical Engineering 0
Comsol moving boundary+ Heat Transfer Mechanical Engineering 8
COMSOL - moving boundary - internal oxidation Mechanical Engineering 0
PDE in COMSOL with moving boundary General Math 0
Problem with a boundary condition in Comsol Math & Science Software 0