Comsol moving boundary with loss of mass


by SSS_04
Tags: comsol, dgeometry, mesh, moving boundary, moving mesh
SSS_04
SSS_04 is offline
#1
Jan30-13, 08:26 AM
P: 1
I need some help!My problem is a problem of moving boundary with loss of mass.... I started to use COMSOL and I need to simulate one plate with a hole on the center. And this hole is increasing with the time according to one equation (like a velocity, in m/s) which depend of the stress. Someone knows how to do this? Can I do this whit the moving mesh? Or I should use the DG?
Thank you!
Phys.Org News Partner Engineering news on Phys.org
Fiber-optic microscope will help physicians detect cancer, diseases at early stages
Wind tunnel tests support improved aerodynamic design of B61-12 bomb
Smart sensor technology to combat indoor air pollution
niklas.r
niklas.r is offline
#2
Feb7-13, 03:09 AM
P: 2
It is not clear to me what exactly you mean with mass loss here. If the structure is changing shape due to applied stress (->strain), use the Moving Mesh interface. If the structure is changing shape due to material removal/addition, use the Deformed Geometry interface. This link gives some more info:
http://www.comsol.com/support/knowledgebase/970/
regards
Niklas (COMSOL employee)
ishantj
ishantj is offline
#3
Feb7-13, 06:22 AM
P: 2
This might help you in explanation.


Register to reply

Related Discussions
COMSOL moving boundary model Mechanical Engineering 0
Comsol moving boundary+ Heat Transfer Mechanical Engineering 8
COMSOL - moving boundary - internal oxidation Mechanical Engineering 0
PDE in COMSOL with moving boundary General Math 0
problem with a boundary condition in Comsol Math & Science Software 0