Baluncore's latest activity

This LTspice model is sufficient to model the signal passing through a via. T1 is the line on one side of the PCB. T2 will become the...

Tektronix produced this 114 page reference. Time-Domain Reflectometry Measurements, by James A. Strickland...

Here is a simple TDR simulated in LTspice. Remove the .txt extensions from both files, then run the LTspice file.asc Start by changing...

TDR is a plot of impedance (driver voltage) against reflection time. Z = √( L / C ) You cannot say if it is the inductance or the...

What you show is a 3-layer PCB, which is not used in practice. This point made by @Baluncore should be emphasized. It is generally a...

Then you would have seen a "tripler" circuit in a CRT monitor, driven by the horizontal output transformer...

That is because the output voltage is to be negative relative to ground, as in the diagram in post #1. I think in post #1, they are...

You have two tracks with known impedance, joined through the PCB by a short cylindrical via. The via will probably not match the...

Welcome to PF. This basic schoolwork question does not involve detailed values like frequency and parasitics. It is just a basic...

Welcome to PF. This is a problem of understanding how the circuit works, assuming perfect components. If you specify the frequency...

I have not got it running yet. Your gate bias was a problem. See attached.

In a way, but not to reduce rolling resistance. There is no fear of flipping backwards since you regulate body position and pedal force...

Flipping over backwards is totally unnecessary. As an amateur cyclist wearing cleats, I could lift the front wheel just off the ground...

I think you assume a front wheel hop from a body bounce, while holding the handlebars. I assume the front wheel lifts due to pedal...

Take a look at a book of physics formulas. https://www.amazon.com.au/dp/B0BDXFMG5M/