thanks anorlunda
you are right i have many more question and i will describe it here to get the right answer but i just wait to order my questions
thanks again
you are right
first i will design a machine that cut the metal sheet to parts by hand , after i will get a roll of sheet metal and cut it to specific lengths automatically
the tool will be manual now , but in the future will be automatic
what you mean by continuous or cyclic ?
i designing the equipment
about the longevity and maintenance it depends on the cost
but if so the area of this triangle is too small because the sheet thickness is 1.5 mm
so if the area is 8 mm2 , UTS is 370 n/mm2 then the force = 0.7*370*8 = 2072 N
is it right ?
the area in blue will change from start from 1300 mm at the start of cutting process and ends at the end of the cutting process and the change will be in mm , and according to this equation the value of shear force will change as the area changes ?
thanks for reply ,but if the sheet to be cut is 1.25 mm thickness and 1300 mm and have UTS of 350 n/mm2 and the angle blade is 15 degree
so what is the cutting force required ?
will it be 420875 N or less or more ?