Recent content by jags

helo cyrus,check this link 01.http://www.zenithair.com/kit-data/ht-87-5.html

hey abhidaviator then why these softwares are called design and drafting .You said its only for modeling ,u r totally wrong man .There are aproximately 84 modules in catia v6, modeling is one of them.

catia v6 is the best

It may help u 01.http://www.tutorvista.com/content/physics/physics-iii/oscillations/simple-pendulum.php

The angle of plane is given 20degree the force is resolved into two component that is 1.Horizontal component formula fx=cos(angle)f1 2.Vertical component fy=sin(angle)f1 Determine the net force here is the formula total force=sqrt(fx^2+fy^2) this is the exact solution

Hey dude apply l-hospital rule when there is 0/0 form after putting x=0 in the original equation , now differentiate the equation not in u/v form differentiate upper equation and lower equation differently until u got the equation not in the form 0/0 after putting the value

Buy the brushless motor under the specification Power: 200 Watts *.RPM/Volt (KV): 1000 *.Continuous Current: 6-15A *.Burst Current: 19A*

U need to buy high torque and low rpm motor to drive the shaft

Okay, it depend upon specific heat.I got it thanks for link i print it out.

Book didnt explain specific heat.

0„2When one steps from a shower on a cold morning, why doesthe tile floor seem so much colder than the air?

Img uploded suggest me

01.http://img2.orkut.com/images/milieu/1/1213787033773/32174292/pt/Zpog0ya.jpg How to post image here Its our rc car driven by 3.2 hpi engine 2 speed transmission system, bell crank steering mechanism , fuel use nitro+mthnol its a two stroke engine two wheel drive question:how to increase...

Thank you for ur information

What is slip in tube drive shaft ? How it is different from other drive shafts i.e1-piece and 2-piece drive shaft?And what is suitable material of drive shaft ,can we use shaft in bicycle ?