Recent content by Wasure

I will need to collect the temperature as well I have not started yet, but I do know that the flow will be fast since I will be using pressure around the range of 500 psi.

Well, that's one question down on how discharge coefficient is useful, but would the manufacturer know the discharge coefficient if I designed the injector plate assembly on my own by just estimating ideal parameters based on other injector plate assemblies that have performed well? I guess...

I can use hot wire anemometry to measure turbulent intensity. It should be a decent and manageable method. I think the only drawback to it might be the response time. I'm actually not too sure how knowing this can be useful. Would it even be practical to measure it using cold flow?I can use...

Perhaps it would be better to have a larger ship with a lower acceleration?

I am interested in research on hybrid rocket technology and I would like to know if anyone has a known ideal way to measure the required parameters to find the below items. I am particularly interested in a cold flow test involving: Characteristics of the Oxidizer Flow Turbulent Intensity...

I'm at the point now where I'm wondering which parameters I should focus on when looking at the oxidizer flow. I guess I should look at designing an injector plate that is capable of regulating the oxidizer flow?

This is a great start. I didn't consider that I would need two injector plate designs. I guess it does make sense from a scientific perspective so that I can compare my design with a general design. I intend on employing both experimental and simulation methods to test whether my design is...

Well, I majored in aerospace engineering for undergraduate and I'm pursuing a masters now. I want to model the geometry of the injector plate in such a way that it will improve the regression rate. Then I need to find how what design I need to test in order to attempt this. That's going to be...

Hello, First of all, I hope this post is in the right section (aerospace engineering). I am doing research on the injector plate design for a hybrid rocket and I'm no where at the moment. I was thinking that I could improve the geometry of the injector plate in order to help improve some...