Agitator Choice: Impeller Design

2 replies · 5K views · last reply
rollingstein
Messages
644
Reaction score
16
I've an impeller choice to make for a stirred tank reactor and would love some opinions. Essentially, I've a three level agitator as shown in the sketch I made. RPM is fixed (~85 rpm).

My real choice is only what combination of the two impeller designs I choose. Would you go for a pitched blade turbine in the middle (to provide axial flow) and two curved blade turbines at top and bottom to provide shear? Or all curved?

Any other ideas? I'd love to simulate this too (if this is a feasible proposition for a non-CFD expert). Overall I hope to have good circulation as well as a good phase mixing (i.e. droplet formation)

The fluid isn't very viscous (~10 cP) but has two immiscible phases (Specific Gravity difference ~0.1 gm/cc). Tank holds ~14,000 Litres and has a 30 hP motor.

Sketch of a stirred tank with a three-level agitator driven from a motor on top, two baffles and a dashed liquid level line; inset shows two impeller types, a pitched blade and a curved blade.


PS. If a mod can resize the IMG tag that'd help me! Not sure what attributes it takes.
 
Last edited:
Have you tried http://www.haywardgordon.com/technical-information2.htm
 
Last edited by a moderator:
chemisttree said:
Have you tried http://www.haywardgordon.com/technical-information2.htm

Good link! Thanks.

I hadn't tried, no.
 
Last edited by a moderator: