Build a LCD Flicker Meter Using Photodiode and Current Amp

  • Level: Graduate 
  • Thread starter Eddie13
  • Start date
  • Tags Tags
    Lcd Measuring
1 reply · 2K views · last reply
Eddie13
Messages
1
Reaction score
0
I need help in building a LCD flicker meter using photodiode and a current amplifier.

The aim is measure the LCD pixels's flicker that can be detected by human eye so as to have a representation as electrical signal. This is to use it in cases where it's hard to judge if there is a flicker noise present or not, or if it happens only once in a while.

There is a big range of photodiodes available with frequencies up to GHz for optical communication. LCD refresh rate is 60Hz (so assuming this fact LCD flicker would also be <60Hz or assume <120Hz to be detected by human eye). Since flicker will appear as distortion (or may be RGB pixels in off state), I assume some filtering will be involved..

Any ideas?
 
My first guess would be to first amplify the photodiode signal using an opamp and then send the amplified signal to a low pass filter (first/second order?).