Current in resistor network with 40.7 V between points a and b

  • Thread starter Jnblose
  • Start date
  • Tags Tags
    Electricity
5 replies · 3K views · last reply
Jnblose
Messages
7
Reaction score
0

Homework Statement


f a voltage of 40.7 V is applied between points a and b, find the current in each resistor.

The drawing looks like this (idk how to add a picture here) A-[ ]-/\/-[ ]-B In between brackets (space at top and bottom are resistors)... top of the first (A) is 12, bottom 6, middle there is one (designated by /\/) at 5. On top and bottom of B are 4 and 8 respectively.

Homework Equations





The Attempt at a Solution

First question is Find the equivalent resistance between point a and b. So I tried to break them down and do Rab (hypothetically) as 1/r1 + 1/r2 so 1/12 + 1/6 = .25 then I made a Rcd (hypothetically) and did 1/r4 + 1/r5 which is 1/4 + 1/8 = .375 then I added R3 to get the total R which would be +5 so answer would be 5.625 This was marked incorrect. Then it says if a voltage 40.7 is applied b/t a and B find current in each resistor. There I am completely lost but I attempted something random and got of course a wrong answer.
 
I can't follow your description of the diagram. If you can scan one in, you can attach it to your message. Or post it to a site like photobucket.com and give us a link. Some are putting (IMG) and (/IMG), with square brackets instead of round, around the link so it shows up as an image in the post.

Perhaps you could just describe it better. The current goes through the 12 ohm resister . . .
 
http://www.webassign.net/sercp/p18-18alt.gif

Circuit schematic with three branches between two vertical rails: top branch has battery ΔV1 and resistor R, middle has battery ΔV2 and 6.0 Ω resistor, bottom has battery ΔV3 and 2.0 Ω resistor; left side has 10 Ω and 5.0 Ω resistors in series, with terminals a and b between them.
 
Last edited by a moderator:
Hi,

you have to calculate for the 12 and 6 Ohm the following:

1/12 + 1/6 = 1/r_1 so r_1 = 6*12/(6 + 12) = 4 = 1/0.25.

So 0.25 is wrong. Do the same for 1/4 + 1/8 = 1/r_3 -> r_3.
r_2 = 5 Ohm.

So R = r_1 + r_2 + r_3.
Now you have I = U/R (between a and b) with U = 40.7 V.
Try to figure out the other currents by yourself.