How to find the time-base setting for a cathode ray oscilloscope

  • Thread starter Janiceleong26
  • Start date
  • Tags Tags
    Base Time
3 replies · 7K views · last reply
Janiceleong26
Messages
276
Reaction score
4

Homework Statement



Exam diagram of a flywheel with a magnet M on its rim passing a coil wired to a cathode-ray oscilloscope whose 10 cm display width is marked, with four time-base options A to D below.

How to find the time-base setting?

Homework Equations


None

The Attempt at a Solution


Firstly, I calculated the period of the revolution..
3000 Rev -> 60s
1 Rev -> 0.02s
Then, how to calculate the time base setting?

Do we need to estimate which is the most suitable one?
If the display is 10cm wide then, 0.1/0.02= 5 rev ?
 
Yes, estimating the most suitable one is the way to go. Work out how many cycles of the signal will appear on the display for each of the timebase settings and select one that will most distinctly show (to the naked eye) separate pulses.
 
gneill said:
Yes, estimating the most suitable one is the way to go. Work out how many cycles of the signal will appear on the display for each of the timebase settings and select one that will most distinctly show (to the naked eye) separate pulses.
Ok, thanks !
 
This is a tricky question. Obviously the slowest setting will show the most pulses, but will they appear too close together? The fastest setting might show only one pulse or only part of it. Also the pulse should go both positive and negative (volts) as the magnet passes the coil.