Magnetic field in a solenoid using sin(θ₂) − sin(θ₁) formula

1 reply · 2K views · last reply
Special One
Messages
32
Reaction score
1
Homework Statement
Explain how did we get the formula used in the question answer.
Relevant Equations
Magnetic field
Problem 52:
A solenoid is 40 cm long, has a diameter of 3.0 cm, and is wound with 500 turns. If the current through the windings is 4.0 A, what is the magnetic field at a point on the axis of the solenoid that is (a) at the center of the solenoid, (b) 10.0 cm from one end of the solenoid, and (c) 5.0 cm from one end of the solenoid? (d) Compare these answers with the infinite-solenoid case.

Three diagrams (a, b, c) of a 40 cm solenoid shown as a column of cross-sectional circles with X marks, with a point on the axis at 1.5 cm from the coil, showing angles θ1 and θ2 to the top and bottom turns.
Handwritten solution to Problem 52 on a solenoid's magnetic field, showing parts (a) through (d) with B = μ0IN/2L (sinθ2 − sinθ1) worked out numerically at each point.

I didn't get the second half of the formula, which is ( sinΘ2-sinΘ1 ) ?
And why when we substitute we consider the Θ1 as negative??
 
Is the posted work under Problem 52 your attempt at a solution? If yes, then you should know where the ##(\sin\theta_2-\sin\theta_1)## term came from; it has to do with the fact that the solenoid is finite. If that's someone else's solution, please post your attempt and we'll take it from there. Once you have correctly derived (with perhaps some help) your own equation, then you will know why ##\theta_1## is taken negative.