Too many members at one node to solve with equilibrium equations?

1 reply · 2K views · last reply
e_brock123
Messages
13
Reaction score
0
Hi I’m doing a project where we have to design a truss. I’ve made a design and I’ve figured out the reaction forces. There is a support in the middle and one on the left side, both of them are only vertical reactions and finally there is a load of 250N on the right being applied.

I don’t expect anyone to do this for me, but I’m just wondering if there is not enough information, or there’s too many members passing through one node to solve using the three equations of equilibrium.

I’ve attached the design and sorry for the messy writing. Could someone please suggest which joint to start at and what process I have to use there?
 
Attachments
  • Hand-drawn truss diagram on lined paper, with labelled joints A to N and M, a 240mm span, and a 250N load F at the right. Ty = 250N at the top left and Gy = 500N at the bottom centre are marked, with working for the moment equations below.
    warren hybrid.jpg
    24.7 KB · Views: 465
Looks like an unorthodox way to support a truss. The members to the left of TC and to the right of KV don't do anything. The vertical and short diagonals also carry no force...you'd need them perhaps to brace compression members against buckling.. Otherwise, the Truss is statically determinate.