| Thread Closed |
PSPICE help |
Share Thread |
| Nov29-05, 01:27 AM | #1 |
|
|
PSPICE help
Is there a way to tell PSPICE to graph a signal without having to go to Trace>Add-Trace and selecting the signals each time? If I added a signal and then change a component value slightly and run the simulation, is there a way I can refresh the signal without having to go through the add trace method over and over again?
|
| Nov29-05, 09:35 AM | #2 |
|
Mentor
|
I don't know about PSPICE, but in MicroCAP, the plot setup is sticky. What analysis are you running (AC, DC, Transient, etc.)?
|
| Nov29-05, 10:42 AM | #3 |
|
|
I am trying to perform AC analysis. Thank you for your reply.
|
| Nov29-05, 11:05 AM | #4 |
|
Mentor
|
PSPICE help
Do you have the Student Edition of PSPICE? If so, I won'der if the sticky nature of plot setups is disabled for that edition. Maybe check out the readme/help files about setting up the plot configurations, and also the limitations of the Student Edition.
|
| Feb22-10, 10:34 PM | #5 |
|
|
Hi frndz can anyone tell me hw to plot steady state temperature of resistor using pspice.
|
| Thread Closed |
Similar discussions for: PSPICE help
|
||||
| Thread | Forum | Replies | ||
| PSPICE Help | Electrical Engineering | 2 | ||
| Pspice capture help | Electrical Engineering | 9 | ||
| need help with Pspice | Electrical Engineering | 15 | ||
| download the Orcad PSpice software | Electrical Engineering | 5 | ||
| pspice help asap | Electrical Engineering | 4 | ||
