Recent content by fpdlskf

Problem is simplied. Assume ideal gas @ atm pressure & temperature. Completely seal the needle end of a syringe. Assume bottom end of syringe is completely sealed (can move in axial direction). Q1. If I press on the syringe (pressurize inside), is if correct to say that the pressure...

Yes. I plan to spend all of my free time killing monsters Korean style ~~!

before and after pics?

The amount of $$ required for the launch attempt is about the same amount of $$ to feed the entire NK population for a year. According to The Daily Focus (A South Korean internet based newspaper) - have no idea on its credibility though...

I can't seem to find anything about the heat treatment specific to austenitic stainless steels. (e.g. SS 304, SS 316L) The info I need is pretty much everything that has to do w/ the heat treatment of stainless steels (benefits, procedure/process, equipment ...) The only thing I have...

Hi to all. How would I go about calculating the fatigue limit of leaf springs? Is there an equation out there in the form of N, cycles to failure= f(variables, material properties) Or will I have to use the Stress equations for leaf springs and use that stress value and then...

First of all, thanks for all the helpful comments to my previous posts. I'm trying to get a grasp of stress tensors and have been doing some studying. In the literature I've been looking at, it says something about the eigenvalues of stress tensors and the principle stresses. This is...

Thanks for the reply. Neither. By edge joint I mean something like this..

I've looked everywhere and can't seem to find any information. Would someone be kind enough to point me to some literature?

I need to calculate strengths of welds / welded joints. Could you point me to a handbook or website? I will be a bit more specific. The welds are fusion welding w/o any filler materials and the materials to be welded are thin strips of stainless steel (thickness 5/1000 in)