Recent content by garr6120

Im doing a lab on an online software called beyond labs. On this software I am able to test gas laws by adding ideal and real gasses to a balloon in a pressure chamber. When I am conducting the test I have a consistent temperature of 298K and .300 moles across all the tests; the only variables...

I mean when the ALU uses arithmetic sorry.

I was wondering what the carry (C) equation for the logic gates would be in an ALU status register? I originally thought that it was C equals the last carry output. However, my colleagues tell me its C equals to the sum of the last bit primed AND the last carry output. Can someone clarify my...

I don’t use it for every circuit only ones that I use voltmeters for. Was to lazy to take it out

That’s because of the node right?

Can I add the two resistors the 4 ohm and 2 ohm?

I have one circuit and another with a source transformation figure a and b respectively. My question after transforming the 30 mA source shouldn't the current going into node 5 equal the current going into node 4? Figura a. Before the transformation of the source Figure b. After the...

Would the infinite current in the series circuit run through the transistor and voltage source causing them both to have a voltage value of 0?

If I have a resistor and a voltage source in series but then I apply a short circuit in parallel to both of them would the voltage source and resistor not receive 0 V? Thus having 0 current. What would change in the circuit?

I thought the 12 V source wouldn't receive any current because of the open circuit. Should I use KVL because when i make a loop at the open circuit i get: -24V-2mA*12Ω=-12V

Even if it is i can correct it when I am done because its an arbitrary polarity. If i get negative for my answer I have to flip the polarity at the end so that if i recalculate my final answer the answer will be positive. So its just a prior guess right now. but here it is.

+ to - from left to right.

- V2Ω + with the - charge facing the 0V wire