Recent content by Setareh7796

  1. S

    Engineering How does feedback affect the transfer function of an integrating block?

    The correct solution is different than my answer, I am not sure where I am going wrong?
  2. S

    Understanding Bending Moment Calculations in Mechanical Systems

    The full question is: For the purpose of analysis, a segment of a crankshaft in a vehicle is presented as shown in Figure Q5. The load P = 1 kN, and the dimensions are b1 = 80 mm, b2 = 120 mm and b3 = 40mm. The diameter of the shaft is d = 20 mm. Determine the maximum tensile, compressive and...
  3. S

    Understanding Bending Moment Calculations in Mechanical Systems

    But the correct solution is M= P* (b2+b1). I don't understand how b2+b1 is the perpendicular distance.
  4. S

    Sketching the graph of a function

    I have attached the full question as stated in the problem sheet. I am just stuck in the sketching part.
  5. S

    Sketching the graph of a function

    I have no idea why my sketch is wrong.
  6. S

    Finding equations of motion of multi degree freedom system

  7. S

    Will the Internal Gear Rotate with Gear 1? - Gear Rotation Question

    If gear 1 fits into the internal gear and is made to rotate, will the internal gear rotate with gear 1? https://imgur.com/gallery/ELYZoRb
  8. S

    The time for pressure to build up

    From my understanding, the pressure in the cylinder will be at atmospheric pressure at the start.
  9. S

    The time for pressure to build up

    Homework Statement The volume and dimensions of the cylinder are given, and the air is supplied to the cylinder at 4 bar at room temperature.Is there a way to find out the time it takes for the air pressure in the cylinder to increase to 4 bar? Homework EquationsThe Attempt at a Solution From...