How do I simplify a circuit with 3 and 2 ohm resistors?

  • Topic: Engineering 
  • Thread starter RiceKernel
  • Start date
  • Tags Tags
    Circuit
2 replies · 2K views · last reply
RiceKernel
Messages
17
Reaction score
0

Homework Statement



Circuit schematic for problem 2.44 with terminals a and b at left and bottom left; resistors labeled 5 ohm, 20 ohm, 2 ohm and 3 ohm, with a wire running across the top.


Homework Equations


Req =R1 + R2

Req = (R1*R2)/(R1 +R2)


The Attempt at a Solution



No idea how to do that . Was thinking maybe making the 3 and 2 ohms resistors equivalent (assuming parallel). I have no idea what to do with the top wire . How do I simplify this circuit?
 
The 2 and 3 Ohm resistors are not in parallel (their upper ends are not connected).

Hint: Re-draw the circuit with the 5 and 20 Ohm resistors in a vertical position.
 
RiceKernel said:

Homework Statement



Circuit schematic with terminals a and b, a 5 Ω and 20 Ω resistor in series on the top branch, a 2 Ω resistor in a vertical branch, and a 3 Ω resistor on the right, with a wire looping over the top.


Homework Equations


Req =R1 + R2

Req = (R1*R2)/(R1 +R2)


The Attempt at a Solution



No idea how to do that . Was thinking maybe making the 3 and 2 ohms resistors equivalent (assuming parallel). I have no idea what to do with the top wire . How do I simplify this circuit?

You're allowed to re-arrange the components on the page so long as all the connections remain the same. Take a close look at how the 5 and 20 Ohm resistors are connected. Better yet, move terminals a and b to the other end of the circuit. You can do this because a continuous wire path is all the same node, and anything connected to it can be moved to another point on the same conductor.

Circuit schematic with a 5 Ω resistor and a 20 Ω resistor in series along the top, a 2 Ω resistor and a 3 Ω resistor hanging down in parallel from that line, and a wire loop over the top joining the left end of the 5 Ω resistor to the node between the 20 Ω resistor and terminal a. Terminals a and b are at the right.
 
Attachments
  • Circuit schematic with a 5 Ω and a 20 Ω resistor in series along the top branch, a 2 Ω resistor and a 3 Ω resistor hanging down in parallel from the nodes, and terminals labeled a and b.
    Fig1.gif
    3.9 KB · Views: 560