How to analyze diode circuits? (Find waveform generated)

2 replies · 2K views · last reply
eehelp150
Messages
235
Reaction score
0

Homework Statement


To analyze these circuits, we need to draw the current path right? I know that current can only flow one direction through a diode.
http://i.imgur.com/kipBcax.png

Homework Equations


N/A

The Attempt at a Solution


Are these paths correct? Green = positive, red = negative
1. Positive edge can only go through diode 1, so the positive edge gets clipped to +0.7V. Negative edge can only go through diode 2, so negative edge gets clipped to -0.7V
http://i.imgur.com/Sx8MvpY.png

2. Positive edge of top waveform can go through top diode. Negative edge of top waveform cannot.
Positive edge of bottom waveform cannot go through bottom diode. Negative can.
Results in rectified wave form capped at 5.6V due to the Zener
http://i.imgur.com/XYa5e5H.png

3. Don't really know how this one works

4. The waveform for this would 'start' from 4.3V (5V - 0.7V) and get clipped at 12.74V (14.14V - 2x0.7V)
http://i.imgur.com/iTStF8O.png

5. The positive edge can go through the diode but the negative one cannot. What would the waveform look like?
http://i.imgur.com/DoMnqwM.png

Am I doing these questions right?
 
Attachments
  • Hand-drawn schematic set of five diode circuits: transformer-fed diode clippers, a zener-regulated rectifier, a bridge rectifier with two load resistors, a bridge with a shunt zener, and a clipper with a source and ideal diode.
    upload_2016-11-1_16-44-44.png
    52.2 KB · Views: 649
eehelp150 said:
1. Positive edge can only go through diode 1, so the positive edge gets clipped to +0.7V. Negative edge can only go through diode 2, so negative edge gets clipped to -0.7V
Check out this thread from the beginning.
https://www.physicsforums.com/posts/5590333/