Rated Current and Current in mini split Air Conditioner

  • Thread starter Thread starter Shervan360
  • Start date Start date
  • Tags Tags
    Ac Cooling
AI Thread Summary
The discussion focuses on comparing two mini split air conditioners with the same cooling capacity but different current ratings. The first unit has a rated current of 9.56 A, while the second has a current of 9.9 A and a rated current of 16 A. The higher rated current of the second unit may indicate it can draw more power, potentially leading to increased energy consumption and higher bills. However, if both units typically operate around 9.5–10 A, the difference in energy use may not be significant. Understanding the power usage and efficiency ratings is crucial for making an informed decision.
Shervan360
Messages
26
Reaction score
4
Hello,



I am seeing two mini split ACs with the same cooling capacity in two different companies. Both 24000 BTU and Inverter.



The first one said Rated Current is 9.56 A and didn't write Max current or current.

The second one said the Current is 9.9 A and the Rated Current is 16 A.



Does it mean the second one can draw up to 6 A more? (more electrical consumption? and more electrical bills?



Thank you


Screenshot 2024-04-26 203237.png


Screenshot 2024-04-26 203259.png
 
Engineering news on Phys.org
No, that's just startup current. Look at the power usage and/or EER/COP.
 
  • Informative
  • Like
Likes Shervan360 and berkeman
russ_watters said:
No, that's just startup current. Look at the power usage and/or EER/COP.
Thank you, but I don't understand. The first one Rated Current is 9.56 and the second one is in 16 A.
 
I don't think "rated current" is an established technical term and they are using it differently.

Though maybe the second unit has electric resistance backup heat?
 
Only if the ductless mini split air conditioner consistently runs at a higher current. If both units normally run around 9.5–10 A, you won’t see a big difference. But if the second ductless mini split air conditioner often ramps up to near its 16 A, it could consume more energy over time.
 
Last edited:
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Back
Top