Solving Makefile Confusion for Fortran Code

[DrClaude]

Do you mean the whole code, or just the module spincohere?

The whole code is VERY long! I'd imagine it would take quite a while to actually go through. I never even went through it all in its entirety...@_@

Just spincohere.

 

[Matterwave]

Just spincohere.

I have messaged it to you. Thanks. :D

 

[DrClaude]

I have messaged it to you. Thanks. :D

I had a look, and there is no problem there. I now realize that I misread something in the error message you posted, and it should've been clear to me that the error was not in your code.

I'll get back to you tomorrow.

 

[Matterwave]

I had a look, and there is no problem there. I now realize that I misread something in the error message you posted, and it should've been clear to me that the error was not in your code.

I'll get back to you tomorrow.

Ok thanks!

 

[Matterwave]

I had a look, and there is no problem there. I now realize that I misread something in the error message you posted, and it should've been clear to me that the error was not in your code.

I'll get back to you tomorrow.

I have figured it out! I needed to install liblapack-dev instead of just liblapack3 as well. Now my code runs! But now I have more questions, which, since it has nothing to do with this make file, I will now post in a separate thread.