Voltage at the output/Parallel resistors

2 replies · 2K views · last reply
dalarev
Messages
94
Reaction score
0

Homework Statement



Reading the voltage taken at the output, Vo.

Homework Equations



Resistors in parallel carry the same voltage.

The Attempt at a Solution



The circuit shown in the diagram, the output is taken directly in parallel with Ro, so shouldn't that mean that:

VRL = VRD = Vro ?

In calculating the output, they combine all those 3 resistors in parallel into RL', I don't understand why.


In other words, why doesn't Vo = VRL ?
 
Attachments
  • Small-signal equivalent circuit of a MOSFET amplifier with source Vsig and Rsig feeding gate G, Cgd between G and D, Cgs, gm Vgs controlled current source, ro, RD and RL to output Vo, with R'L marking the parallel combination at the drain-to-source node.
    Capture.PNG
    15.9 KB · Views: 521
The output voltage is indeed the voltage across those three parallel resistor components. It doesn't matter if they are drawn as 3 resistors or the equivalent single resistor, unless some individual current is needed for some other part of the model calculation.
 
I might be repeating the above post:

The circuit shown in the diagram, the output is taken directly in parallel with Ro, so shouldn't that mean that:

VRL = VRD = Vro ?
Yes

In calculating the output, they combine all those 3 resistors in parallel into RL', I don't understand why.
You don't know the voltage across either of those three. But the total current passing through all three resistors is g_m*V_gs which is known as I am assuming. You can go solve the circuit in either way: it's a simple circuit with three resistors in parallel and one current source. Simplest possible method is to combine all three ll resistors and find the voltage.